Configuring Policy Server Centerd Debug

Policy Server debug settings are not supported in the web console, so they must be configured in CLI mode.

Debug settings allow you to preemptively identify problems with the Genian NAC appliance or determine the cause of issues if they occur.

Configuring Debug in CLI Console

For CLI console access methods, please refer to the CLI Console document.

  1. Perform CLI console access by entering Username and Password.
  2. Activate global configuration mode using the enable command.
  3. Enter configuration mode using the configure terminal command.
  4. Activate debug by entering the debug centerd all command.
  5. Confirm that debug is configured by entering the show configuration command. This command can also be used in Genian general CLI, not just Configuration mode.
genian> enable
Password :
genian# configure terminal
genian(config)# debug centerd all
genian(config)# show configuration

# If debug is configured successfully
debug centerd category 0xffffffff
debug centerd field 0x31d