.. _debug-centerd:

Configuring Policy Server Centerd Debug
=============================================

Policy Server debug settings are not supported in the web console, so they must be configured in CLI mode.

Debug settings allow you to preemptively identify problems with the Genian NAC appliance or determine the cause of issues if they occur.

Configuring Debug in CLI Console
------------------------------------

For CLI console access methods, please refer to the :ref:`cliconsole` document.

#. Perform CLI console access by entering Username and Password.
#. Activate global configuration mode using the **enable** command.
#. Enter configuration mode using the **configure terminal** command.
#. Activate debug by entering the ``debug centerd all`` command.
#. Confirm that debug is configured by entering the **show configuration** command. This command can also be used in Genian general CLI, not just Configuration mode.

::

    genian> enable
    Password :
    genian# configure terminal
    genian(config)# debug centerd all
    genian(config)# show configuration
    
    # If debug is configured successfully
    debug centerd category 0xffffffff
    debug centerd field 0x31d